在使用饺子皮机的过程中，难免会遇到一些情况。以下是饺子包皮机的常见故障及排除方法，供您参考和学习。

　　 1. The machine panel of the dumpling wrapper cannot be connected normally

　　 Failure reason: This situation is generally due to the improper gap between the two sets of upper and lower rollers of the dumpling wrapper machine, resulting in a broken or remaining plate.

　　 Solution: When the plate is broken, the gap between the lower pair of rollers can be reduced, or the gap between the upper pair of rollers can be increased, and the adjustment method of the remaining plate is just the opposite of that of the broken plate.

　　2, the noodles are off-track, inconsistent in thickness

　　Failure reason: This situation is usually caused by uneven gaps in the length direction of the roller.

　　Solution: Properly adjust the adjustment wire on the surface roller of the dumpling wrapper machine until it fits.

　　3, the edge of the dough piece is incomplete

　　 Failure reason: usually the edge of the dough piece is broken due to uneven feeding. Dumpling wrapper machine

　　 Solution: When feeding the dough, it is enough to maintain a continuous and even feeding.

　　 4. Dumpling wrapper machine noodle roll stick noodle

　　 Failure reason: The sticky surface of the roller is generally due to the bad contact of the scraper.

　　Solution: Suitable for adjusting the position of the blade of the machine scraper for dumpling wrappers.

　　5, the patch has a curved wave

　　 Failure reason: In this case, the angle between the roller and the scraper is generally too large, or it may be that the scraper is upside down or the blade is relatively blunt.

　 Solution: Check whether the installation angle of the scraper of the dumpling wrapper machine is appropriate; check whether the scraper is upside down, and install the scraper correctly; check whether the blade is dull, if it is dull, sharpen the blade and install it.