粉碎榨汁机适用于各种新鲜果蔬的打浆分离。它由前支架、给料斗、粉碎、螺杆、滤网、榨汁机、后支架、渣槽等部分组成。螺杆主轴的左端支承在滚动轴承座上，右端支承在手轮轴承座上。电动机螺旋由一对v型皮带轮驱动工作。

　　Material of crushing juicer: Choose food grade stainless steel material, this kind of material cannot be absorbed by magnets, it is corrosion-resistant and easy to clean. Plastic and stainless iron material that can be attracted by magnets, juice is easy to be oxidized, and the material is easy to be corroded by juice, rust and produce bacteria.

　　 Crushing Juicer * Mesh design: It is an easy to wear part, and the household appliance industry has introduced a titanium-plated coating, which greatly improves the hardness and service life of the * mesh. Diameter is also an important indicator. Large diameters can continuously maintain the juice yield. Small diameters are easy to be blocked by juice and cannot be juiced for a long time.

　　The working method of crushing juicer:

　　 The rotation direction of the screw spindle is clockwise when viewed from the feed hopper to the slag trough. The raw materials are added to the hopper and pressed under the advancement of the screw. The squeezed juice flows into the juicer at the bottom through the filter, while the waste is discharged through the annular gap formed between the screw and the conical part of the pressure regulation. The movement of the pressure regulating head along the axial direction can adjust the size of the gap. It is used for clockwise (when looking from the slag discharge trough of the equipment to the hopper end, when the bearing seat is turned when the handwheel shaft is turned, the pressure regulating head is turned to the left, and the gap is reduced, otherwise the gap becomes larger.) Change the size of the gap, that is, adjust the row Resistance of slag. The slag extraction rate can be changed, but if the gap is too small, under strong squeezing, part of the slag particles will be squeezed out through the filter together with the juice. Although the juice output increases, the quality of the juice is relatively reduced. The size of the gap should be determined. It depends on the user's specific process requirements.